I just pulled the plug on a 6000.

To many ads? Support ODJT and see no ads!
MIXMASTERMACHOM

MIXMASTERMACHOM

DJ Extraordinaire
ODJT Supporter
Oct 16, 2011
14,843
2,316
65
I just bought a few minutes ago a Denon DN MC 6000 controller from Guitar Center for all together $321. It should be here sometime this week. Cosmetically it's not that good looking. As long as it works then I'm OK with it. I have a way to get it done for now playing for the seniors when it gets here.

At least I have 2 laptops, portable HD with my music on it, a corded mic and the wire to hook into the controller to the laptop. My spirit is way up from before. I'm no longer in the problem and working on the solution.
 
  • Like
Reactions: CurtissTheDJ, PhaseIIPro and sonic-vision
MIXMASTERMACHOM said:
I just bought a few minutes ago a Denon DN MC 6000 controller from Guitar Center for all together $321. It should be here sometime this week. Cosmetically it's not that good looking. As long as it works then I'm OK with it. I have a way to get it done for now playing for the seniors when it gets here.

At least I have 2 laptops, portable HD with my music on it, a corded mic and the wire to hook into the controller to the laptop. My spirit is way up from before. I'm no longer in the problem and working on the solution.
Click to expand...
 
tunes4046 said:
MK1 or MK2 version
Click to expand...

Not sure the answer matters, to be honest. Both versions are 10 years old and considered obsolete at this point. The most recent drivers for the MC6000 were released in 2015.
 
  • Like
Reactions: PhaseIIPro and ittigger
B-Sharp said:
Not sure the answer matters, to be honest. Both versions are 10 years old and considered obsolete at this point. The most recent drivers for the MC6000 were released in 2015.
Click to expand...
I can get the drivers for either one.
 
Adrian , Pick up a nice set of 10 inch speakers that will get you by so as to save up for your bigger . You will be amazed at the sound modern day 10" can sound .
easy on your body and you will be able too put on stands. run a compresser , you be amazed by the low end you will produce .😌
 
  • Like
Reactions: ittigger, Jeff Romard and PhaseIIPro
www.facebook.com

Musician's Friend

Gemini UHF-6200M UHF Dual Handheld System, 512-537.5mHz - Only $99.95 (Was: $199.95). Limited quantities, while supplies last.
www.facebook.com www.facebook.com
 
  • Like
Reactions: ittigger and PhaseIIPro
I'm not rebuilding. Work fine for your needs.
I use 4 each ElectroVoice er-2
1100 frequencies too scan.
2- handheld/ two lapel for outdoor ceremonies.
New, No less than $500.00 for one MIC, receiver.
Used Telex 25 years ago & both work as backup.
 
Last edited:
  • Like
Reactions: ittigger, Jeff Romard and PhaseIIPro
sonic-vision said:
I'm not rebuilding. Work fine for your needs.
I use 4 each ElectroVoice er-2
1100 frequencies too scan.
2- handheld/ two lapel for outdoor ceremonies.
New, No less than $500.00 for one MIC, receiver.
Used Telex 25 years ago & both work as backup.
Click to expand...
I hear you. My concern is that it's made by Gemini and the cost. Has anybody used that specific dual wireless mics?
 
MIXMASTERMACHOM said:
I hear you. My concern is that it's made by Gemini and the cost. Has anybody used that specific dual wireless mics
Click to expand...
Check out reviews on youtube. DJ Mikey Mike has had luck with Gemini
 
  • Like
Reactions: ittigger
You only have 11 and a half hours to makeup your mind! :djsmug:
 
  • Haha
Reactions: ittigger
  • Like
Reactions: ittigger and Jeff Romard
You must log in or register to reply here.
Top Bottom
Back